Removal / installation · Vehicles built from Nov 2005
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).
NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.
Do not put the connector bracket directly onto a work table. Otherwise, the connector bracket of the front seat adjuster will be deformed and cause interference with peripheral parts such as the under tray.
HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).
2.
REMOVE FRONT SEAT HEADREST ASSEMBLY
Push in the lock button of the front seat headrest support and remove the front seat headrest.
3.
REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)
Remove the front seat under tray.
4.
REMOVE FRONT SEAT ASSEMBLY
Disconnect the buckle switch connector.
w/ Front Seat Side Airbag:
Slide the slider and disconnect the airbag connector.
Move the front seat to its most rearward position.
Using "Torx" socket wrench E10, remove the 2 bolts from the front side.
Move the front seat to its most forward position.
Using "Torx" socket wrench E10, remove the 2 bolts from the rear side and the front seat.