2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Aug 2005

NOTICE:
Always use "Torx" socket wrench E10 when installing the rear seat.


1. INSTALL REAR SEAT ASSEMBLY

  1. B114684E01
    Insert the 2 location pins through the 2 body holes and install the rear seat.

  1. Using "Torx" socket wrench E10, install the 4 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. B114660E01
    Install the rear seat cushion.

  1. Using "Torx" socket wrench E10, install the 2 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }


2. INSTALL NO. 1 REAR SEAT LEG COVER

  1. B114659
    Engage the 4 claws and install the No. 1 rear seat leg cover.


3. INSTALL DECK FLOOR BOX (w/ Deck Board)

  1. B106446
    Set the deck floor box and lock the 2 knobs.


4. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B119913
    Install the spare wheel cover.


5. INSTALL DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106447
    Set the deck board and lock the 2 knobs.


6. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

7. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Engage the 2 claws and install the package tray trim panel.

  1. Install the 5 pieces of hook tape.

  1. Install the 2 package tray trim suspenders.

← REASSEMBLY (from Aug 2005)COMPONENTS (from Aug 2005) →