DISASSEMBLY
Removal / installation · Vehicles built from Aug 2005
- CAUTION:
- Wear protective gloves. Sharp surfaces on the rear seat cushion frame and the rear seatback frame could cause injuries to your hands.
| 1. REMOVE REAR CENTER SEAT INNER BELT ASSEMBLY RH |
for 3 Point Type Rear Center Seat Belt:

Remove the bolt and the rear center seat inner belt.
for 2 Point Type Rear Center Seat Belt:

Remove the tongue plate.
Remove the bolt and the rear center seat inner belt.
| 2. REMOVE REAR CENTER SEAT INNER BELT ASSEMBLY LH |
Remove the belt from the band.

Remove the bolt and the rear center seat inner belt.
| 3. REMOVE REAR SEAT INNER BELT ASSEMBLY |
Remove the belt from the band.

Remove the bolt and the rear center seat inner belt.
| 4. REMOVE REAR SEAT SIDE HINGE COVER |
Disengage the 4 claws and remove the rear seat side hinge cover.

| 5. REMOVE REAR SEAT CUSHION ASSEMBLY |
Using "Torx" socket wrench T45, remove the bolt and the spacer.

Remove the 2 nuts and the rear seat cushion.
| 6. REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY |
Remove the 7 hog rings.

Disengage the 7 hooks and remove the rear seat cushion cover pad.
| 7. REMOVE REAR SEAT HEADREST ASSEMBLY |
Push in the lock button of the rear seat headrest support and remove the rear seat headrest.

| 8. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY (w/ Rear Center Seat Headrest) |
Push in the lock button of the rear seat headrest support and remove the rear center seat headrest.

| 9. REMOVE REAR SEAT LOCK STRIKER COVER |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear seat lock striker cover.

| 10. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY |
Remove the 2 screws.

Disconnect the rear seat reclining control cable and the rear seat slide control cable and remove the rear seat lock control lever.
| 11. REMOVE REAR SEAT HEADREST SUPPORT |
w/ Tether Anchor Cover:

- HINT:
- Use the same procedure for the both sides.
Disengage the 2 claws and open the cover.
Remove the screw and the tether anchor cover.

Remove the 2 rear seatback cover bands.

Remove the 7 hog rings.

Unfasten the 2 zippers.

for 3 Point Type Rear Center Seat Belt:
Remove the bolt and the rear seat belt hook.
w/ Rear Center Seat Headrest:

- HINT:
- Use the same procedure to remove all the rear seat headrest supports.
Disengage the 2 claws and remove the rear seat headrest support.
w/o Rear Center Seat Headrest:
- HINT:
- Use the same procedure to remove all the rear seat headrest supports.
Disengage the 2 claws and remove the rear seat headrest support.
| 12. REMOVE REAR SEATBACK COVER PAD SUB-ASSEMBLY |
Remove the rear seatback cover pad.

| 13. REMOVE REAR SEAT UNDER TRAY COVER |
Using a clip remover, remove the 6 clips and the rear seat under tray cover.

| 14. REMOVE REAR SEAT RECLINING OUTSIDE COVER LH |
Remove the screw and the rear seat reclining outside cover.

| 15. REMOVE REAR SEAT RECLINING OUTSIDE COVER RH |
Remove the 2 screws and the rear seat reclining outside cover.

| 16. REMOVE REAR SEAT RECLINING INSIDE COVER |
Disengage the 2 claws and remove the rear seat reclining inside cover.

| 17. REMOVE RECLINING ADJUSTER INSIDE COVER LH |
Remove the screw.

Disengage the claw and remove the reclining adjuster inside cover.
| 18. REMOVE RECLINING ADJUSTER INSIDE COVER RH |
- HINT:
- Use the same procedure as for the LH side.
| 19. REMOVE REAR SEAT RECLINING CONTROL CABLE |
Remove the rear seat reclining control cable.

| 20. REMOVE REAR SEAT SLIDE CONTROL CABLE |
Remove the rear seat slide control cable.

Remove the 5 clips.

| 21. REMOVE REAR SEAT TRACK ASSEMBLY LH |
Remove the 2 nuts and the rear seat track.

| 22. REMOVE REAR SEAT TRACK ASSEMBLY RH |
Remove the 3 nuts and the rear seat track.

