2005-2008 Yaris · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. REMOVE SPEEDOMETER DRIVE GEAR

C067982
  1. Remove the speedometer drive gear from the front differential case.


2. REMOVE FRONT DIFFERENTIAL RING GEAR

D032380E01
  1. Place matchmarks on the front differential ring gear and the front differential case.

  1. Remove the 8 bolts.

  1. C067984
    Using a plastic hammer, remove the front differential ring gear from the front differential case.


3. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

C067989
  1. Fix the front differential pinion to the front differential case side. Using a dial indicator, measure the front differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    If the backlash is outside the specifications, replace the side gear thrust washers.


4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

C067985
  1. Using a chisel and a hammer, loosen the staked part of the front differential case.

  1. C067986
    Using a pin punch (φ3 mm) and a hammer, remove the front differential pinion shaft straight pin from the front differential case.


5. REMOVE NO. 1 FRONT DIFFERENTIAL PINION SHAFT

C067987
  1. Remove the No. 1 front differential pinion shaft from the front differential case.


6. REMOVE FRONT DIFFERENTIAL SIDE GEAR

C067988
  1. Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 No. 1 front differential side gear thrust washers and 2 front differential side gears from the front differential case.

    HINT:
    Revolving the front differential pinion, remove the 2 pinions and 2 side gears.

← COMPONENTS (from Nov 2006)INSPECTION (from Nov 2006) →