ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jan 2006
| INSPECT FRONT NO. 1 SPEAKER ASSEMBLY |
- HINT:
- Remove interior parts so that the front No. 1 speaker can be seen.
Check the installation.
- OK:
- The speaker is securely installed.
Visually check the speaker.
- OK:
- The cone paper of the speaker is not torn.
Check the resistance.

Disconnect the speaker connector.
Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Specified Condition
1 - 2
Approximately 4 Ω
