2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2006

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

HINT:
Use the same procedure as for the LH side (Click here).


3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:
Use the same procedure as for the LH side (Click here).


4. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the LH side (Click here).


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the LH side (Click here).


6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

  1. B134972
    Disconnect the speaker connector.

  1. B134969
    Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the front No.1 speaker.

  1. Operate the drill around the rivet head circumference and cut out the flange.

    CAUTION:
    Be careful. The cut rivet is very hot.

    NOTICE:
    Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

  1. After drilling out the flange, continue drilling to push out the shards on the drill.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

← ON-VEHICLE INSPECTION (from Jan 2006)INSTALLATION (from Jan 2006) →