REASSEMBLY
Removal / installation · Vehicles built from Jan 2006
| 1. INSTALL STRUT MOUNTING BEARING |
![]() ![]() |
Using a brass bar and press, install the strut mounting bearing onto the coil spring seat upper.
- NOTICE:
- The strut mounting bearing must be securely installed.
| 2. INSTALL FRONT COIL SPRING |
![]() ![]() |
Using SST, compress the coil spring.
- SST
- 09727-30021
(09727-00010, 09727-00021, 09727-00031)
- NOTICE:
- Do not use an impact wrench. It will damage SST.
Install the coil spring onto the shock absorber.
- NOTICE:
- A spring of a smaller diameter should be installed in the upward direction.
- HINT:
- Fit the lower end of the coil spring into the gap of the absorber lower seat.
| 3. INSTALL FRONT COIL SPRING UPPER INSULATOR |
| 4. INSTALL FRONT SPRING BUMPER |
![]() ![]() |
Install the spring bumper onto the coil spring seat upper with the air discharge groove of the spring bumper and the rib portion of the coil spring seat upper aligned.
- NOTICE:
- Securely insert the spring bumper into the coil spring seat upper.
| 5. INSTALL FRONT COIL SPRING UPPER SEAT |
Install the coil spring seat upper with the strut mounting bearing and spring bumper onto the shock absorber.
| 6. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT |
Provisionally tighten a new nut.
Remove SST from the front coil spring.
- NOTICE:
- Do not use an impact wrench. It will damage SST.
Using a socket hexagon wrench 6, fix the shock absorber rod and tighten the nut.

- Torque:
- 33 N*m{ 340 kgf*cm , 25 ft.*lbf }
| 7. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY |



