2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.


3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106371
    Release the 2 knobs and remove the deck board.


4. REMOVE DECK FLOOR BOX RH (w/ Deck Board)

  1. B106372
    Release the 2 knobs and remove the deck floor box.

    HINT:
    Remove the deck floor box LH when removing the LH side.


5. REMOVE DECK FLOOR BOX LH (w/ Deck Board)

HINT:
Use the same procedure as for the RH side.


6. REMOVE REAR SEAT BACK ASSEMBLY

  1. B108442
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat back.


7. REMOVE REAR SEAT CUSHION COVER PAD

  1. B117740
    Hold the front edge of the rear seat cushion and lift it up, as shown in the illustration, to disengage the the 2 rear seat cushion lock hooks.

    NOTICE:
    Hold the area around the rear seat cushion hooks so as to avoid deforming the rear seat cushion frame.

  1. Pass the rear seat inner belt through the slit in the rear seat cushion, disengage the hook between the rear seat cushion and rear seat back, and remove the rear seat cushion.


8. REMOVE FRONT DOOR SCUFF PLATE

  1. B114284
    Disengage the 8 claws and remove the front door scuff plate.


9. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B114477
    Remove the front door opening trim weatherstrip to the extent that the front quarter trim panel can be removed.


10. REMOVE REAR SEAT OUTER BELT ASSEMBLY

  1. B114498
    Remove the belt.


11. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

  1. B114499
    Disengage the 8 clips, the retainer and the 10 claws and remove the front quarter trim panel.


12. REMOVE SEAT BELT ANCHOR COVER CAP

  1. B114478
    Disengage the 3 claws and remove the seat belt anchor cover cap.


13. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

  1. B114496
    Remove the anchor plate cover.

  1. B114497
    Remove the bolt and the anchor plate.

  1. B114479
    Remove the bolt and the through anchor.

  1. B114422E01
    Disconnect the pretensioner connector.

    1. Using a screwdriver, release the locking button.

    2. Using a screwdriver, disconnect the pretensioner connector.

  1. B114423
    Remove the 2 bolts, the 2 hooks and the retractor.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →