2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

NOTICE:
Always use "Torx" socket wrench E10 when removing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for LH Side)

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

  1. B114569E01
    Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.


3. REMOVE DECK BOARD SUB-ASSEMBLY

  1. B106371
    Release the 2 knobs and remove the deck board.


4. REMOVE DECK FLOOR BOX RH

  1. B106372
    Release the 2 knobs and remove the deck floor box.


5. REMOVE DECK FLOOR BOX LH

HINT:
Use the same procedure as for the RH side.


6. REMOVE REAR SEAT CUSHION COVER PAD

  1. B117740
    Hold the front edge of the rear seat cushion and lift it up, as shown in the illustration, to disengage the the 2 rear seat cushion lock hooks.

    NOTICE:
    Hold the area around the rear seat cushion hooks so as to avoid deforming the rear seat cushion frame.

  1. Pass the rear seat inner belt through the slit in the rear seat cushion, disengage the hook between the rear seat cushion and rear seat back, and remove the rear seat cushion.


7. REMOVE REAR SEAT BACK ASSEMBLY

  1. B108442
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat back.


8. REMOVE FRONT DOOR SCUFF PLATE

  1. B114660
    Using "Torx" socket wrench E10, remove the 2 bolts and pull up the rear seat cushion.

  1. B119885
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.


9. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B138507
    Remove the front door opening trim weatherstrip.


10. REMOVE REAR SEAT SHOULDER BELT HANGER

  1. B114498
    Remove the belt of the rear seat outer belt.

  1. B114484E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear seat shoulder belt hanger.


11. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

  1. B114499
    Disengage the 8 clips, the retainer and the 10 claws and remove the front quarter trim panel.


12. REMOVE REAR DECK TRIM COVER

  1. B117692
    for Temper Spare Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.

  1. B114283
    for Grand Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.


13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY

  1. B114500
    Remove the bolt.

  1. Disengage the clip and remove the anchor plate of the rear seat outer belt.

  1. B114501
    for RH Side:

    1. Remove the 3 screws.

    2. Disengage the 3 clips and the 3 claws and remove the deck trim side panel.

  1. B114502
    for LH Side:

    1. Remove the 3 screws.

    2. Disengage the 3 clips and the 3 claws.

    3. Disconnect the luggage compartment room light connector and remove the deck trim side panel.


14. REMOVE ROOF SIDE INNER GARNISH

  1. B173323E01
    for RH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. Disengage the 4 clips and the claw.

    2. Pass the rear seat outer and rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B173324
    for RH Side (w/o Curtain Shield Airbag):

    1. Disengage the 4 clips and the claw.

    2. Pass the rear seat outer and rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B114506E01
    for LH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. Disengage the 4 clips and the claw.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B114507
    for LH Side (w/o Curtain Shield Airbag):

    1. Disengage the 4 clips and the claw.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.


15. REMOVE REAR SEAT OUTER BELT ASSEMBLY

  1. B114482
    Remove the bolt and the through anchor.

  1. B114483
    Remove the bolt, the 2 hooks and the retractor.


16. REMOVE SEAT BELT HOLE SEAL

  1. B114436
    Disengage the 2 claws and remove the seat belt hole seal.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →