2005-2008 Yaris · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Jan 2006


1. INSTALL REAR SUSPENSION SUPPORT ASSEMBLY

2. INSTALL REAR SUSPENSION SUPPORT STOPPER

3. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER

C106031
  1. Support the axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.

  1. Jack up the axle beam slowly, and provisionally install the shock absorber (lower side) with the bolt and nut onto the axle beam.

  1. Install the suspension support and cushion retainer.

  1. C106033
    While holding the piston rod, install a new nut (lower nut) to the specified standard.

    Standard:
    15 to 18 mm (0.591 to 0.709 in.)

  1. C132100
    While holding the piston rod, tighten a new nut (upper nut).

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }


4. INSTALL REAR SHOCK ABSORBER CAP

5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


6. STABILIZE SUSPENSION
  1. Lower the vehicle from the jack.

  1. Bounce the vehicle up and down several times to stabilize the suspension.


7. FULLY TIGHTEN REAR SHOCK ABSORBER
  1. Fully tighten the shock absorber (lower side) with the bolt.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


8. INSTALL REAR SEATBACK ASSEMBLY (for Fixed Seat Type)

  1. B134981
    Engage the 3 hooks and install the rear seatback.

  1. Tighten the 3 bolts.

    Torque:
    7.9 N*m{ 80 kgf*cm , 70 in.*lbf }

  1. B138450E01
    Install the rear seat outer belt into the rear seat shoulder belt guide.

    HINT:
    Use the same procedure for both sides.

  1. for 3 Point Type Rear Center Seat belt:

    1. Install the rear center seat outer belt into the rear center seat shoulder belt guide.


9. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

  1. B138623
    Pass the rear seat inner belt through the rear seat cushion cover pad slit.

  1. Engage the 3 hooks and install the rear seat cushion cover pad.

    NOTICE:
    SE Make sure that the 2 rear seat cushion lock hooks and the rear seat cushion frame are securely engaged.


10. INSPECT REAR WHEEL ALIGNMENT
(Click here)
← INSPECTION (from Jan 2006)DISPOSAL (from Jan 2006) →