2005-2008 Yaris · Service Manual STEERING

TERMINALS OF ECU

System information · Vehicles built from Aug 2005

F044303E02
Symbols (Terminals No.)
Terminal Description
Condition
Specified Condition
PIG (A19-1) - PGND (A19-2)
EPS fuse
Always
10 to 16 V
PGND (A19-2) - Body ground
Body ground
Always
Below 1 Ω
M1 (b1-1) - PGND (A19-2)
Power steering motor
  1. With ignition switch on (IG), turn steering wheel to left
  2. With ignition switch on (IG), turn steering wheel to right
  1. 10 to 16 V (LHD)
    Below 1 V (RHD)
  2. Below 1 V (LHD)
    10 to 16 V (RHD)
M2 (b1-2) - PGND (A19-2)
Power steering motor
  1. With ignition switch on (IG), turn steering wheel to left
  2. With ignition switch on (IG), turn steering wheel to right
  1. Below 1 V (LHD)
    10 to 16 V (RHD)
  2. 10 to 16 V (LHD)
    Below 1 V (RHD)
CANH (D31-1) - CANL (D31-7)
CAN BUS
Ignition switch off
108 to 132 Ω
SIL (D31-2) - PGND (A19-2)
DLC3
Communication established by connecting intelligent tester to DLC3
Pulse generation
(See waveform 1)
IG (D31-6) - PGND (A19-2)
ECU-IG fuse
Ignition switch on (IG)
10 to 16 V
TS (D31-11) - PGND (A19-2)
DLC3
Ignition switch on (IG)
10 to 16 V
SPD (D31-5) - PGND (A19-2) *
Speed signal
Ignition switch on
Pulse generation (See waveform 2)
TRQ1 (c1 -5) - PGND (A19-2)
Torque sensor
With ignition switch on (IG), turn steering wheel to left and right
0.3 to 4.7 V
TRQV (c1-6) - PGND (A19-2)
Torque sensor
Ignition switch on (IG)
7.5 to 8.5 V
TRQ2 (c1-7) - PGND (A19-2)
Torque sensor
With ignition switch on (IG), turn steering wheel to left and right
0.3 to 4.7 V
TRQG (c1-8) - PGND (A19-2)
Torque sensor
Always
Below 1 Ω
*: w/o ABS

Waveform 1
C081996E02
Reference 
Terminal
SIL - Body ground
Tool setting
5 V/DIV, 1 ms/DIV
Condition
Communication established by connecting intelligent tester to DLC3

Waveform 2
C053421E05
Reference 
Terminal
SPD - Body ground
Tool setting
5 V/DIV, 20 ms/DIV
Condition
Vehicle speed approximately 20 km/h (12.4 mph)
← PROBLEM SYMPTOMS TABLE (from Jan 2006)DIAGNOSIS SYSTEM (from Aug 2005) →