2005-2008 Yaris · Service Manual STEERING

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built from Aug 2005


CHECK DLC3

  1. F100115E31
    Check the DLC3:
    The power steering ECU uses CAN (ISO11898-1) and ISO9141-2 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO9141-2 format.
    Symbols (Terminal No.)
    Terminal Description
    Condition
    Specified Condition
    SIL (7) - SG (5)
    Bus [+] line
    During transmission
    Pulse generation
    CG (4) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    SG (5) - Body ground
    Signal ground
    Always
    Below 1 Ω
    BAT (16) - Body ground
    Battery positive
    Always
    11 to 14 V
    CANH (6) - CANL (14)
    HIGH-level CAN bus line
    Ignition switch off
    54 to 67 Ω
    CANH (6) - Battery positive
    HIGH-level CAN bus line
    Ignition switch off
    1 MΩ or higher
    CANH (6) - CG (4)
    HIGH-level CAN bus line
    Ignition switch off
    3 KΩ or higher
    CANL (14) - Battery positive
    LOW-level CAN bus line
    Ignition switch off
    1 MΩ or higher
    CANL (14) - CG (4)
    LOW-level CAN bus line
    Ignition switch off
    3 KΩ or higher

    HINT:
    If the display shows [UNABLE TO CONNECT TO VEHICLE] after connecting the intelligent tester cable to the DLC3 and the ignition switch on (IG), there is a problem either with the vehicle or the tester.
    1. If communication is normal when connecting the tester to another vehicle, inspect the DLC3 on the original vehicle.
    2. If communication is still not possible when connecting the tester to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's operator's manual.


WARNING LIGHT
F100395E02
  1. When a problem occurs in the electronic power steering system, the P/S warning light on the combination meter comes on to inform the driver of the problem.

← TERMINALS OF ECU (from Aug 2005)DTC CHECK / CLEAR (Aug 2005 – Dec 2005) →