2005-2008 Yaris · Service Manual STEERING

TS and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

The power steering ECU can be changed from normal mode to the mode for the torque sensor zero point calibration by turning the ignition switch on (IG) after the DLC3 TS and CG terminals have been connected.

WIRING DIAGRAM

C117901E01

INSPECTION PROCEDURE


1. INSPECT DLC3 TERMINAL VOLTAGE
F100115E29
  1. Turn the ignition switch on (IG).

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Specified Condition
    TS (12) - CG (4)
    10 to 14 V



OK
END
NG


2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
F100115E10
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    CG (4) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - DLC3)

  1. C122912E01
    Disconnect the connector from the power steering ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    TS (D31-11) -TS (12)
    Below 1 Ω
    TS (D31-11) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU


← EPS Warning Light Circuit (from Aug 2005)COMPONENTS (from Jan 2006) →