2005-2008 Yaris · Service Manual STEERING

EPS Warning Light Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

If the power steering ECU detects a malfunction, the P/S warning light comes on. At this time, the power steering ECU stores a DTC in its memory.

WIRING DIAGRAM

C122325E01
C120680E02

INSPECTION PROCEDURE


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Using the intelligent tester, check for DTCs and confirm that there are no problems in the CAN communication system.

    OK:
    DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM
OK


2. READ VALUE OF DATA LIST (IG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the item [IG Power Supply] in the DATA LIST and read value displayed on the intelligent tester.

    Standard voltage:
    10 to 16 V

    HINT:
    If the voltage is not standard value, inspect IG power source circuit (Click here ).



NG
INSPECT POWER SOURCE CIRCUIT (IG)
OK


3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)
F046436E01
  1. Disconnect the connectors from the power steering ECU.

  1. Measure the voltage and the resistance.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    IG (D31-6) - Body ground
    Ignition switch on (IG)
    10 to 16 V
    PGND (A19-2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. REPLACE POWER STEERING ECU

NOTICE:
After replacing the power steering ECU, perform the torque sensor zero point calibration.


NEXT


5. CHECK P/S WARNING LIGHT (COMBINATION METER)
  1. Check that the P/S warning light on the combination meter does not come on.

    OK:
    The P/S warning light does not come on.



NG
REPLACE COMBINATION METER
OK

END


← U0073 Control Module Communication Bus OFF (+ U0105, U0121) (from Aug 2005)TS and CG Terminal Circuit (from Aug 2005) →