REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 3.
DRAIN BRAKE FLUID |
 |
- NOTICE:
- Immediately wash off any brake fluid that comes into contact with any painted surfaces.
| 4.
SEPARATE SKID CONTROL SENSOR WIRE |
 |
Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.
- NOTICE:
- Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.
- Remove the nut and separate the skid control sensor wire.
| 5.
SEPARATE REAR LH FLEXIBLE HOSE |
 |
Using SST, separate the brake tube from the flexible hose.
- SST
- 09023-00100
Remove the clip and disconnect the flexible hose from the axle beam.
| 6.
SEPARATE REAR RH FLEXIBLE HOSE |
 |
- HINT:
- The removal procedure for the RH side is the same as that for the LH side.
| 7.
LOOSEN REAR AXLE BEAM |
 |
Loosen the 2 bolts.
- NOTICE:
- Do not remove the bolts.
| 8.
REMOVE REAR ABSORBER CAP |
|
| 9.
REMOVE REAR SHOCK ABSORBER CAP LH |
|
| 10.
REMOVE REAR SHOCK ABSORBER CAP RH |
|
| 11.
REMOVE REAR SHOCK ABSORBER LH
|
 |
Support the axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.
- Remove the 2 nuts while keeping the piston rod from rotating.
Remove the cushion retainer and suspension support.
- Remove the bolt while keeping the nut from rotating and remove the shock absorber.
- NOTICE:
- Remove the nut from the bolt side because the one on the lower side is a jam nut.
| 12.
REMOVE REAR SHOCK ABSORBER RH |
 |
- HINT:
- The removal procedure for the RH side is the same as that for the LH side.
| 13.
REMOVE REAR COIL SPRING LH |
 |
Lower the jacks slowly.
Remove the coil spring, coil spring insulator upper and coil spring insulator lower.
| 14.
REMOVE REAR COIL SPRING RH |
 |
- HINT:
- The removal procedure for the RH side is the same as that for the LH side.