ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY |
Pull back the floor carpet.
Check that the pedal height is correct.

- Pedal height from floor:
- 122.4 to 132.4 mm (4.819 to 5.213 in.) 1KR-FE/2SZ-FE
- 133.0 to 143.0 mm (5.236 to 5.630 in.) 1ND-TV
If the pedal height is not as specified, adjust it as follows.
Loosen the lock nut and turn the stopper bolt until the correct height is obtained.
Tighten the lock nut.
- Torque:
- 16 N*m{ 160 kgf*cm , 12 ft.*lbf }
| INSPECT AND ADJUST PEDAL FREE PLAY AND PUSH ROD PLAY |
![]() ![]() |
Check that the pedal free play and push rod play are correct.
Depress the pedal until clutch resistance begins to be felt.
- Pedal free play:
- 8.0 to 15.0 mm (0.315 to 0.591 in.)
Gently depress the pedal until the resistance begins to increase a little.
- Push rod play at pedal top:
- 1.2 to 7.8 mm (0.047 to 0.307 in.)
| INSPECT AND ADJUST CLUTCH RELEASE POINT |
![]() ![]() |
Check the clutch release point.
Pull the parking brake lever and install a wheel stoppers.
Start the engine and run it at idle.
Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears come into contact.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.
- Standard distance:
- 25 mm (0.98 in.) or more (From pedal stroke end position to release point)
- Check pedal height.
- Check push rod play and pedal free play.
- Bleed the clutch line.
- Check the clutch cover assembly and disc assembly.


