2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

C136386
  1. Install the clutch master cylinder so that its flat section is at a right angle to the pedal.

  1. C115307
    Install the clutch master cylinder with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }


2. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C115313
  1. Using SST, connect the flexible hose tube.

    SST
    09023-00101  

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }


3. INSTALL CLUTCH RESERVOIR TUBE
  1. Connect the clutch reservoir tube to the clutch master cylinder assembly with the clip.


4. INSTALL BRAKE BOOSTER ASSEMBLY
(Click here)

5. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
  1. Pull back the floor carpet.

  1. C127616E01
    Check that the pedal height is correct.

    Pedal height from floor:
    122.4 to 132.4 mm (4.819 to 5.213 in.) 1KR-FE/2SZ-FE
    133.0 to 143.0 mm (5.236 to 5.630 in.) 1ND-TV

  1. If the pedal height is not as specified, adjust it as follows.

    1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

    2. Tighten the lock nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }


6. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

  1. B114572
    Engage the 3 claws and install the instrument panel under cover.

  1. Tighten the 2 screws.

← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →