INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1.
INSTALL CLUTCH DISC ASSEMBLY |
 |
Insert SST into the clutch disc assembly, then insert them both into the flywheel sub-assembly.
- SST
- 09301-00110
- NOTICE:
- Insert clutch disc assembly in the correct direction.
| 2.
INSTALL CLUTCH COVER ASSEMBLY |
 |
Align the matchmark on the clutch cover assembly with that on the flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin at the top.
-
Torque:
- 19 N*m{
195 kgf*cm
, 14 ft.*lbf
}
- HINT:
- Following the order in the illustration, tighten the bolts evenly one at a time.
- Move SST up and down, right and left lightly after checking that the disc is in the center, and tighten the bolts.
- SST
- 09301-00210
| 3.
INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
 |
Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.
- Maximum non-alignment:
- 0.5 mm (0.020 in.)
- If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.
- SST
- 09333-00013
| 4.
INSTALL RELEASE FORK SUPPORT |
 |
Install the release fork support onto the transaxle assembly.
-
Torque:
- 37 N*m{
375 kgf*cm
, 27 ft.*lbf
}
| 5.
INSTALL CLUTCH RELEASE FORK BOOT |
|
| 6.
INSTALL RELEASE BEARING HUB CLIP |
|
| 7.
INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
 |
Apply release hub grease to the contact surfaces of the release fork and release bearing, fork and push rod, and fork and fork support.
- Sealant:
- Toyota Genuine Release Hub Grease or Equivalent
Install the release fork onto the release bearing assembly.
| 8.
INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
 |
Apply clutch spline grease to the input shaft spline.
- Sealant:
- Toyota Genuine Clutch Spline Grease or Equivalent
- NOTICE:
- Do not apply grease to portion A shown in the illustration.
Install the clutch release bearing with release fork onto the transaxle assembly.
- NOTICE:
- After the installation, move the fork forward and backward to check that the release bearing slides smoothly.
| 9.
INSTALL MANUAL TRANSAXLE ASSEMBLY |
 |
(Click here)