2005-2008 Yaris · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT CLUTCH DISC ASSEMBLY

C062956
  1. Using vernier calipers, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in.)

    Replace the clutch disc assembly as necessary.

  1. Install the clutch disc assembly onto the transaxle assembly.

    NOTICE:
    Insert the clutch disc assembly in the correct direction.

  1. D025257E05
    Using a dial gauge, check the clutch disc assembly runout.

    Maximum runout:
    0.8 mm (0.031 in.)

    Replace the clutch disc assembly as necessary.


INSPECT CLUTCH COVER ASSEMBLY

D029069E01
  1. Using vernier calipers, check the diaphragm spring for depth and width of wear.

    Maximum:
    A (Depth): 0.5 mm (0.020 in.)
    B (Width): 6.0 mm (0.236 in.)

    Replace the clutch cover assembly as necessary.


INSPECT FLYWHEEL SUB-ASSEMBLY

C062958
  1. Using a dial gage, check the flywheel sub-assembly runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    Replace the flywheel sub-assembly as necessary.


INSPECT CLUTCH RELEASE BEARING ASSEMBLY

Q001060
  1. Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.

  1. Inspect the clutch release bearing assembly for damage and wear.

    HINT:
    Replace the release bearing assembly as necessary.

← REMOVAL (from Nov 2005)INSTALLATION (from Nov 2005) →