2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL CLUTCH DISC ASSEMBLY

D029848E03
  1. Insert SST into the clutch disc assembly, then insert them both into the flywheel sub-assembly.

    SST
    09301-00110  

    NOTICE:
    Insert the clutch disc assembly in the correct direction.


2. INSTALL CLUTCH COVER ASSEMBLY

D026323E07
  1. Align the matchmark on the clutch cover assembly with that on the flywheel sub-assembly.

  1. Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin at the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Following the order in the illustration, tighten the bolts evenly one at a time.
    2. Move SST up and down, right and left lightly after checking that the disc is in the center, and tighten the bolts.

    SST
    09301-00210  


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

C062961
  1. Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.

    Maximum non-alignment:
    0.5 mm (0.020 in.)

  1. D029849E01
    If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.
    SST
    09333-00013  


4. INSTALL RELEASE FORK SUPPORT

  1. C067604E04
    Install the release fork support onto the transaxle assembly.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }


5. INSTALL CLUTCH RELEASE FORK BOOT

  1. C132156
    Install the clutch release fork support boot to the release fork support as shown in the illustration.


6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

C132154E01
  1. Apply release hub grease to the contact surfaces of the release fork and release bearing assembly, release fork and push rod, and release fork and fork support.

    Sealant:
    Multemp 8158 Grease or the equivalent

  1. Install the release fork onto the release bearing assembly.


7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY
  1. Install the clutch release bearing with release fork onto the transaxle assembly.

  1. C137978E01
    Apply clutch spline grease to the input shaft spline.

    Sealant:
    Toyota Genuine Clutch Spline Grease or the equivalent

    NOTICE:
    1. After the installation, move the fork forward and backward to check that the release bearing slides smoothly.
    2. Do not apply grease to portion A shown in the illustration.


8. INSTALL MULTI- MODE TRANSAXLE
(Click here)
← INSPECTION (from Nov 2005)COMPONENTS (from Aug 2005) →