2005-2008 Yaris · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Nov 2006


INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold tire inflation pressure:
    Tire Size
    Vehicle Speed
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    205/45R17 84W
    Driving below 190 km/h (118 mph)
    200 (2.0, 29)
    190 (1.9, 28)
    Driving over 190 km/h (118 mph)
    220 (2.2, 32)
    210 (2.1, 30)

  1. R003031E01
    Using a dial indicator, check the tire runout.

    Tire runout:
    1.4 mm (0.055 in.) or less


MEASURE VEHICLE HEIGHT

C106034E02

Vehicle height:
A-B
C-D
98 mm
(3.86 in.)
31 mm
(1.22 in.)

Measuring points:
A:
Ground clearance of front wheel center
B:
Ground clearance of lower arm set front bolt center
C:
Ground clearance of rear wheel center
D:
Ground clearance of axle beam set bolt center

NOTICE:
Before inspecting the wheel alignment, check the vehicle height.

HINT:
Bounce the vehicle up and down at the corners to stabilize the suspension before inspecting the vehicle height.


INSPECT TOE-IN

SA03213E02

Toe-in:
A+B
C-D
0°20' +/- 15'
(0.33° +/- 0.25°)
3.5 +/- 3.0 mm
(0.14 +/- 0.12 in.)

HINT:
Only measure C-D when A+B can not be measured.


INSPECT CAMBER
  1. Install the camber-caster-kingpin gauge and position the rear wheel on the alignment tester.

  1. Inspect the camber.

    Camber:
    -0°58' +/- 30' (-0.97° +/- 0.50°)

    NOTICE:
    The tolerance for the difference between the left and right wheels is 30' (0.5°) or less for both cambers.

    If the camber is not within the specified range, inspect the suspension parts and replace them if necessary.

← INSPECTION (from Jan 2006)INSPECTION (from Aug 2005) →