2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Nov 2006

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL SIDE MUDGUARD PROTECTOR

  1. B163739E01
    Install a new side mudguard protector onto the side mudguard.
    Installation position: 
    Mark
    Measurement
    a
    1 mm (0.039 in.)


2. INSTALL SIDE MUDGUARD
  1. Clean the side mudguard (When reusing the side mudguard).

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the rocker panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the side mudguard while it is hot from the infrared light.

      NOTICE:
      Installing the side mudguard while any double-sided adhesive tape remains on the rocker panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the side mudguard.

  1. B163737E01
    Apply new double-sided adhesive tape to the side mudguard installation surface as shown in the illustration.
    Tape A size: 
    a
    55 mm (2.165 in.)
    b
    15 mm (0.591 in.)
    c
    3.5 mm (0.138 in.)
    Tape B size: 
    a
    35 mm (1.378 in.)
    b
    10 mm (0.394 in.)
    c
    3.5 mm (0.138 in.)

  1. Clean the attachment surface.

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the rocker panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the rocker panel while it is hot from the infrared light.

      NOTICE:
      Installing the side mudguard while any double-sided adhesive tape remains on the rocker panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the attachment surface.

  1. B163738E01
    Engage the 8 clips and install the side mudguard.

  1. Press the side mudguard against the vehicle to apply the double-sided adhesive tape.

  1. B121721
    Install the 8 retainers.

  1. Install the screw.

← REMOVAL (from Nov 2006)COMPONENTS (from Aug 2005) →