REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DRAIN BRAKE FLUID |
- NOTICE:
- Immediately wash off any brake fluid that comes into contact with any painted surfaces.
| 2. SEPARATE HOOD TO COWL TOP SEAL |
Disengage the 7 clips and remove the hood to cowl top seal.

| 3. REMOVE COWL TOP NO. 1 VENTILATOR LOUVER CENTER (for LHD) |
Disengage the 2 hooks and remove cowl top ventilator louver center No. 1.

Disconnect the washer hose.
| 4. REMOVE COWL TOP NO. 2 VENTILATOR LOUVER CENTER (for RHD) |
Disengage the 2 hooks and remove cowl top ventilator louver center No. 2.

| 5. REMOVE BATTERY |
| 6. REMOVE BATTERY TRAY |
| 7. REMOVE BATTERY CARRIER |
| 8. SEPARATE BRAKE TUBE (for LHD) |
![]() ![]() |
Using SST, separate the brake tube from the front flexible hose.
- SST
- 09023-00100
Using SST, separate the 2 brake tubes from the brake tube No. 1 way.

- SST
- 09023-00100
- NOTICE:
- To avoid breakage of the brake tube on the body side, hold the brake tube No. 1 way and remove the brake tube.
Using SST, separate the 2 brake tubes from the brake master cylinder.

- SST
- 09023-00100
Using SST, separate the 6 brake tubes from the brake actuator.

- SST
- 09023-00100
Use tags or labels to identify the place to reconnect each brake tube.

Disconnect the brake tube clamp.

| 9. SEPARATE BRAKE TUBE (for RHD) |
![]() ![]() |
Using SST, separate the 6 brake tubes from the brake actuator.
- SST
- 09023-00100
Use tags or labels to identify the place to reconnect each brake tube.

| 10. REMOVE BRAKE ACTUATOR |
![]() ![]() |
While pressing the claw, move the lock lever in the direction of the arrow to release the lock and disconnect the actuator connector from the actuator.
Remove the 3 bolts and the actuator with bracket.

| 11. REMOVE BRAKE ACTUATOR BRACKET |
![]() ![]() |
Remove the 3 bolts and the bracket.
| 12. REMOVE BRAKE ACTUATOR NO. 1 BRACKET |
![]() ![]() |
Remove the 2 bolts and the bracket.





