INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL FRONT SPEED SENSOR |


Install the speed sensor onto the steering knuckle with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Check that the speed sensor tip and installation portion are free of foreign matter.
- Install the speed sensor without turning it from its original installation angle.
- Check that the speed sensor tip and installation portion are free of foreign matter.
Install the clamp onto the shock absorber with the bolt.
- Torque:
- 29 N*m{ 300 kgf*cm , 22 ft.*lbf }
Install the clamp onto the body with the bolt.
- Torque:
- 6.0 N*m{ 61 kgf*cm , 53 in.*lbf }
Install the 3 clips.
Connect the speed sensor connector.
Install the speed sensor clip onto the body.
| 2. INSTALL FRONT FENDER LINER |
Install the front fender liner with the 3 screws, 6 clips and 4 grommets.
- NOTICE:
- The speed sensor wire should not protrude beyond the front fender liner.
| 3. INSTALL FRONT WHEEL |
- Torque:
- 103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 5. CHECK ABS SENSOR SIGNAL (w/o VSC) |
| 6. CHECK VSC SENSOR SIGNAL (w/ VSC) |
