2005-2008 Yaris · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jan 2006


1. INSTALL SKID CONTROL SENSOR
  1. Wipe the sealant off the skid control sensor installation surface using white gasoline.

    NOTICE:
    Keep the sensor rotor free of foreign matter.

  1. C108983E01
    Install the skid control sensor onto the rear axle hub in the highest possible installation position.

    HINT:
    The distance between the installation holes should be larger on the upper side than the lower side.

  1. C108984E01
    Using SST and a press, install a new skid control sensor into the rear axle hub until it is flush with the end.
    SST
    09214-76011  

    NOTICE:
    1. Do not use a hammer when installing.
    2. Check for any foreign matter on the sensor probe.
    3. Press the skid control sensor in slowly without turning it.


2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

C121821
  1. Install the axle hub and bearing onto the axle beam with the 4 bolts.

    Torque:
    90 N*m{ 918 kgf*cm , 67 ft.*lbf }


3. INSPECT REAR AXLE HUB BEARING
  1. Remove the rear wheel.

  1. Remove the rear brake drum (Click here).

  1. C121815
    Inspect the axle hub and bearing backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the axle hub and bearing.

  1. C121816
    Inspect the axle hub and bearing runout.

    1. Using a dial indicator, check the runout of the surface of the axle hub.

      Maximum:
      0.07 mm (0.0028 in.)

      If the runout exceeds the maximum, replace the axle hub and bearing.

  1. Install the rear brake drum.

  1. Adjust the rear drum brake shoe clearance (Click here).

  1. Install the rear wheel.

    Torque:
    103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


4. CONNECT SKID CONTROL SENSOR WIRE

C107565
  1. Connect the skid control sensor wire connector.


5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

6. ADJUST REAR DRUM BRAKE SHOE CLEARANCE

F040023E03
  1. Provisionally install the 2 hub nuts.

  1. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.

  1. Using a screwdriver, release the adjuster 12 notches.

  1. Install the hole plug.


7. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


9. CHECK ABS SENSOR SIGNAL
(Click here)
← INSPECTION (from Jan 2006)COMPONENTS (from Aug 2005) →