2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jan 2006


1. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER

B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.


2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

  1. B132387
    Remove the shift lever knob.


3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B132347
    Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.


4. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY

  1. B132348
    Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the console upper rear panel.


5. REMOVE CONSOLE BOX CARPET

B132346
  1. Remove the console box carpet.


6. REMOVE REAR CONSOLE BOX ASSEMBLY

  1. B132349
    Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.


7. REMOVE REAR WHEEL

8. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.

  1. F046068E02
    Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.


9. REMOVE REAR BRAKE SHOE KIT

C108968E01
  1. Using SST, separate the shoe return spring from the front brake shoe.

    SST
    09703-30010  

    NOTICE:
    Do not damage the wheel cylinder boot.

  1. C108969E01
    Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.
    SST
    09718-00010  

  1. Remove the tension spring.

  1. C108970
    Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.

  1. C108971E01
    Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.
    SST
    09718-00010  

  1. C108972
    Using needle-nose pliers, separate the parking brake cable.


10. REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR

C108997
  1. Remove the 2 nuts and remove the heat insulator.


11. LOOSEN NO. 1 WIRE ADJUSTING NUT

C116905E01
  1. Loosen the lock nut and adjusting nut.


12. REMOVE PARKING BRAKE CABLE
  1. Disconnect the cable end from the equalizer.

  1. Remove cable clamp A from the body.

  1. Remove the 4 bolts.

  1. Using pliers, pinch both ends of the claw of cable clamp B and flex the clamp to remove it.

    C133132E01

  1. C109000
    Remove the bolt and remove the parking brake cable from the backing plate.

  1. Remove the cable clamp B from the parking brake cable.

    HINT:
    Replace the cable clamp B with a new one when installing the parking brake cable.

← COMPONENTS (from Jan 2006)INSTALLATION (from Jan 2006) →