C1541/41 Speed Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2006
Also covers:
- C1542/42 Speed Sensor Malfunction
- C1571/71 Speed Sensor Malfunction (Test Mode DTC)
DESCRIPTION
The power steering ECU controls the assisting power in accordance with the vehicle speed signals from the combination meter.- HINT:
- These DTCs are only for vehicles without a skid control ECU (ABS ECU).
- When the sensor is normal, a pulse signal (43 Hz at 60 km/h [37 mph]) that alternates between 0 V and 5 V is transmitted to the ECU.
| DTC No. |
Detection Item |
Trouble Area |
| C1541/41 |
Speed sensor malfunction. |
|
| C1542/42 | ||
| C1571/71 |
Speed sensor malfunction (Test mode). |
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Confirm that DTC C1571/71 has been cleared by activating test mode after the repair is completed.
| 1. READ VALUE OF DATA LIST (SPD) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Select the item [SPD] in the DATA LIST and read the value displayed on the intelligent tester.
Drive the vehicle and check that there is no significant difference between the speed value displayed by the intelligent tester and the speed value displayed by the speedometer.
- OK:
- Speed values are same.
- HINT:
- There is tolerance of + - 10 % in the speedometer indication.
|
|
||||
| NG | |
| 2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - COMBINATION METER) |
Disconnect the connectors from the power steering ECU and the combination meter.

Measure the resistance.
- Standard resistance:
Tester Connection
Condition
Specified Condition
SPD (D31-5) - 4P OUT (D1-16)
Always
Below 1 Ω
SPD (D31-5) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
