2005-2008 Yaris · Service Manual STEERING

C1551/51 IG Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

The power steering ECU distinguishes the ignition switch status as on (IG) or off through the IG power source circuit.
DTC No.
DTC Detection Condition
Trouble Area
C1551/51
Open or short in IG power source circuit with ignition switch on (IG).
  1. ECU-IG fuse
  2. IG power source circuit
  3. Power steering ECU

WIRING DIAGRAM

C117904E01
C122311E01

INSPECTION PROCEDURE


1. READ VALUE OF DATA LIST (IG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the item [IG Power Supply] in the DATA LIST and read the value displayed on the intelligent tester.

    Standard voltage:
    10 to 16 V



OK
CHECK INTERMITTENT PROBLEMS
NG


2. INSPECT FUSE (ECU-IG)

  1. C120678E01
    Remove the ECU-IG fuse from the main body ECU (instrument panel junction block).

  1. Check the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
INSPECT SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)

  1. F046436E01
    Disconnect the connectors from the power steering ECU.

  1. Measure the voltage and the resistance.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    IG (D31-6) - Body ground
    Ignition switch on (IG)
    10 to 16 V
    PGND (A19-2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU


← C1541/41 Speed Sensor Malfunction (+ C1542/42, C1571/71) (from Jan 2006)C1552/52 PIG Power Source Circuit (+ C1554/54, C1555/55) (Aug 2005 – Dec 2005) →