C1552/52 PIG Power Source Circuit
Diagnostic trouble codes · Vehicles built from Jan 2006
Also covers:
- C1553/53 When Resetting Voltage, Vehicle is Being Driven
- C1554/54 EPS Relay Circuit
- C1555/55 EPS Motor Relay Circuit
Versions by build date: Aug 2005 – Dec 2005 from Jan 2006
DESCRIPTION
When a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because each relay is built into the ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1552/52 |
PIG power source circuit malfunction |
|
| C1553/53 |
Abnormal overvoltage |
|
| C1554/54 |
Power source relay circuit malfunction |
|
| C1555/55 |
Motor relay circuit malfunction |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE OF DATA LIST (PIG POWER SUPPLY) |
Connect the intelligent tester to the DLC3.
Select the item [PIG Power Supply] in the DATA LIST and read the value displayed on the intelligent tester.
- Standard voltage:
- Always 10 to 16 V
|
|
||||
| NG | |
| 2. INSPECT FUSE (EPS FUSE) |
![]() ![]() |
Remove the EPS fuse from the engine room R/B.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND) |
Disconnect the connector from the power steering ECU.

Measure the voltage and the resistance.
- Standard:
Tester Connection
Condition
Specified Condition
PIG (A19-1) - Body ground
Always
10 to 16 V
PGND (A19-2) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT STEERING COLUMN ASSEMBLY (POWER STEERING MOTOR) |
Disconnect the connector from the power steering ECU.

Measure the resistance.
- Standard resistance:
Tester Connection
Condition
Specified Condition
M1 (b1-1) - M2 (b1-2)
Always
0.08 to 0.15 Ω
M1 (b1-1) - Body ground
Always
1 M Ω or higher
M2 (b1-2) - Body ground
Always
1 M Ω or higher
|
|
||||
| OK | ||
| ||

