2005-2008 Yaris · Service Manual STEERING

C1552/52 PIG Power Source Circuit

Diagnostic trouble codes · Vehicles built Aug 2005 – Dec 2005

Also covers:

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006

DESCRIPTION

When a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because each relay is built into the ECU.
DTC No.
DTC Detection Condition
Trouble Area
C1552/52
PIG power source circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU
C1554/54
Power source relay circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU
C1555/55
Motor relay circuit malfunction
  1. Power steering ECU
  2. Steering column assembly (Power steering motor)

WIRING DIAGRAM

C117905E01

INSPECTION PROCEDURE


1. READ VALUE OF DATA LIST (PIG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Select the item [PIG Power Supply] in the DATA LIST and read the value displayed on the intelligent tester.

    Standard voltage:
    Always 10 to 16 V



OK
CHECK INTERMITTENT PROBLEMS
NG


2. INSPECT FUSE (EPS FUSE)
C117909E01
  1. Remove the EPS fuse from the engine room R/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1Ω



NG
INSPECT SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)

  1. F046438E02
    Disconnect the connector from the power steering ECU.

  1. Measure the voltage and the resistance.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    PIG (A19-1) - Body ground
    Always
    10 to 16 V
    PGND (A19-2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. INSPECT STEERING COLUMN ASSEMBLY (POWER STEERING MOTOR)

  1. F046435E01
    Disconnect the connector from the power steering ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    M1 (b1-1) - M2 (b1-2)
    Always
    0.08 to 0.15 Ω
    M1 (b1-1) - Body ground
    Always
    1 M Ω or higher
    M2 (b1-2) - Body ground
    Always
    1 M Ω or higher



NG
REPLACE STEERING COLUMN ASSEMBLY
OK

REPLACE POWER STEERING ECU


← C1551/51 IG Power Supply Voltage Malfunction (from Aug 2005)C1552/52 PIG Power Source Circuit (+ C1553/53, C1554/54, C1555/55) (from Jan 2006) →