2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2005

NOTICE:
Replace the ECM with a new one if necessary.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD)

2. REMOVE FRONT WIPER ARM HEAD CAP (for RHD)

E107882E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.


3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for RHD)
  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. E107883
    Remove the nut and front wiper arm.


4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for RHD)

HINT:
Use the same procedure as for the RH side.


5. REMOVE HOOD TO COWL TOP SEAL (for RHD)

A125202
  1. Disengage the 7 clips and remove the hood to cowl top seal.


6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD)

E113855
  1. Disconnect the washer hose.

  1. Disengage the 10 claws and clip and remove the cowl top ventilator louver sub-assembly.


7. REMOVE COWL TOP VENTILATOR LOUVER LH (for RHD)

E113856
  1. Remove the clip.

  1. Disengage the 4 claws and remove the cowl top ventilator louver LH.


8. REMOVE WINDSHIELD WIPER MOTOR AND LINK (for RHD)

E107890
  1. Remove the 2 bolts.

  1. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.


9. REMOVE COWL TO REGISTER DUCT SUB-ASSEMBLY NO. 2 (for RHD)

A108951
  1. Disengage the claw and remove cowl to register duct sub-assembly No. 2.


10. REMOVE COWL TOP PANEL OUTER (for RHD)

A117320
  1. Disengage the wire harness clamp.

  1. A107444
    Remove the 9 bolts and remove the cowl top panel outer.


11. REMOVE ECM

A115428
  1. Remove the 2 lock knobs and harness clamp.

  1. Disconnect the 2 ECM connectors.

  1. A115432
    Remove the bolt and 2 nuts and the ECM.


12. REMOVE ECM BRACKET

A115430
  1. Remove the 2 screws and remove the ECM bracket.


13. REMOVE ECM BRACKET NO. 2

A115431
  1. Remove the 2 screws and ECM bracket No. 2.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →