REMOVAL
Removal / installation · Vehicles built from Jan 2006
Versions by build date: Aug 2005 – Dec 2005 from Jan 2006
- NOTICE:
- Replace the ECM with a new one if necessary.
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE FRONT WIPER ARM HEAD CAP (for Hatchback)
|
 |
- Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.
| 3.
REMOVE FRONT WIPER ARM HEAD CAP (for Sedan)
|
 |
- Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.
| 4.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for Hatchback)
|
 |
Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
- Remove the nut and front wiper arm.
| 5.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for Sedan)
|
 |
- Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
Remove the nut and front wiper arm.
| 6.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for Hatchback)
|
 |
- HINT:
- Use the same procedure as for the LH side.
| 7.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for Sedan)
|
 |
- HINT:
- Use the same procedure as for the LH side.
| 8.
REMOVE HOOD TO COWL TOP SEAL (for Hatchback)
|
 |
Disengage the 7 clips and remove the hood to cowl top seal.
| 9.
REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY LH (for Sedan)
|
 |
- Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the cowl side ventilator sub-assembly LH.
| 10.
REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY RH (for Sedan)
|
 |
- HINT:
- Use the same procedure as for the LH side.
| 11.
REMOVE COWL TOP VENTILATOR LOUVER LH (for Hatchback)
|
 |
Remove the clip.
Disengage the 4 claws and remove the cowl top ventilator louver LH.
| 12.
REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for Hatchback)
|
 |
Disconnect the washer hose.
Disengage the 10 claws and clip and remove the cowl top ventilator louver sub-assembly.
| 13.
REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for Sedan RHD)
|
 |
- Disengage the 2 clips, the 6 claws and the 10 hooks.
Remove the cowl top ventilator louver sub-assembly.
- Disconnect the washer hoses.
Disengage the 5 hooks.
| 14.
REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for Sedan LHD)
|
 |
- Disengage the 3 clips, the 4 claws and the 8 hooks.
Remove the cowl top ventilator louver sub-assembly.
- Disconnect the washer hoses.
Disengage the 5 hooks.
| 15.
REMOVE WINDSHIELD WIPER MOTOR AND LINK (for Hatchback)
|
 |
Remove the 2 bolts.
Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.
| 16.
REMOVE WINDSHIELD WIPER MOTOR AND LINK (for Sedan)
|
 |
- Remove the 2 bolts.
Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.
| 17.
REMOVE COWL TO REGISTER DUCT SUB-ASSEMBLY NO. 2 (for Hatchback)
|
 |
Disengage the claw and remove cowl to register duct sub-assembly No. 2.
| 18.
REMOVE FRONT AIR SHUTTER SEAL (for Sedan) |
 |
Disengage 3 claws and remove the front air shutter seal.
| 19.
REMOVE COWL TOP PANEL OUTER (for Hatchback)
|
 |
Disengage the wire harness clamp.
- Remove the 9 bolts and remove the cowl top panel outer.
| 20.
REMOVE COWL TOP PANEL OUTER (for Sedan) |
 |
Disengage the claw and disconnect the wire harness.
- Remove the 2 bolts and remove the cowl top panel outer center bracket.
- Remove the 8 bolts and remove the cowl top panel outer.
| 21.
REMOVE ECM |
 |
Remove the 2 lock knobs and harness clamp.
Disconnect the 2 ECM connectors.
- Remove the bolt and 2 nuts and remove the ECM.
| 22.
REMOVE ECM BRACKET |
 |
Remove the 2 screws and the ECM bracket.
| 23.
REMOVE ECM BRACKET NO. 2 |
 |
Remove the 2 screws and ECM bracket No. 2.