2005-2008 Yaris · Service Manual BRAKE

C1251/51 Open in Pump Motor Circuit

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

The motor relay (semiconductor relay) is housed in the skid control ECU and drives the pump motor based on a signal from the skid control ECU.
DTC No.
DTC Detecting Conditions
Trouble Areas
C1251/51
When either of following conditions detected:
  1. Actuator pump motor does not operate properly.
  2. Open in actuator pump motor circuit continues for at least 2 seconds.
Brake actuator

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE


1. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 6 km/h (4 mph) or more for several seconds.

  1. Check if the same DTC is output (Click here ).

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE BRAKE ACTUATOR


← C1249/49 Open in Stop Light Switch Circuit (from Aug 2005)U0073/94 Control Module Communication Bus OFF (from Aug 2005) →