2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT ENGINE COOLANT TEMPERATURE SENSOR

A104779E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      2.32 to 2.59 kΩ at 20°C (68°F)
      1 - 2
      0.310 to 0.326 kΩ at 80°C (176°F)

      If the resistance is not as specified, replace the engine coolant temperature sensor.

      NOTICE:
      Do not immerse terminals on the sensor in the water, while inspecting the engine coolant temperature sensor, as shown in the illustration. After the inspection, wipe the water off the engine coolant temperature sensor so that the terminals do not get wet.

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →