REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN ENGINE COOLANT |
- CAUTION:
- To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.
Install a vinyl hose onto the radiator side.

Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.
Loosen the water drain plug, then drain the coolant.


| 3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
![]() ![]() |
Disconnect the engine coolant temperature sensor connector.
Using SST, remove the engine coolant temperature sensor and gasket.
- SST
- 09817-33190

