INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL FAN AND GENERATOR V BELT |
![]() ![]() |
Install the fan and generator V belt.
Gently tighten bolt B until there is no measurable clearance.
Turn bolt C to adjust the tension of the fan and generator V belt.
Inspect the fan and generator V belt.
Tighten bolt B.
- Torque:
- 34 N*m{ 347 kgf*cm , 25 ft.*lbf }
Tighten bolt A.
- Torque:
- 54 N*m{ 551 kgf*cm , 40 ft.*lbf }
Visually check the generator wiring and listen for abnormal noise.
Check that the wiring is in good condition.
Check that there is no abnormal noise from the generator while the engine is running.
Inspect the discharge warning light circuit.

Turn the ignition switch to the ON position. Check that the discharge warning light illuminates.
Start the engine. Check that the light goes off.
| 2. INSPECT DRIVE BELT DEFLECTION AND TENSION |
![]() ![]() |
Check the belt deflection by pressing on the belt at the points indicated by the arrow marks in the illustration.
- Deflection:
Item
Specified Condition
New belt
7 to 8 mm (0.28 to 0.31 in.)
Used belt
9 to 11 mm (0.35 to 0.43 in.)
- HINT:
- The most appropriate force for the adjustment above is 98 N (10 kgf, 22 lbf).
- New belt refers to a belt which has been used on a running engine for less than 5 minutes.
- Used belt refers to a belt which has been used on a running engine for 5 minutes or more.
- After installing a belt, check that it fits properly in the ribbed grooves.
- Check with your hand to confirm that the belt has not slipped out of the groove on the bottom of the pulley.
- After installing a new belt, run the engine for about 5 minutes and recheck the belt tension.
- The most appropriate force for the adjustment above is 98 N (10 kgf, 22 lbf).
Adjust fan and generator V belt tension.

Loosen bolt A.
Loosen bolt B.
Gently tighten bolt B until there is no measurable clearance.
Turn bolt C to adjust the tension of the fan and generator V belt.
Tighten bolt B.
- Torque:
- 34 N*m{ 347 kgf*cm , 25 ft.*lbf }
Tighten bolt A.
- Torque:
- 54 N*m{ 551 kgf*cm , 40 ft.*lbf }
Visually check the generator wiring and listen for abnormal noises.
Check that the wiring is in good condition.
Check that there is no abnormal noise from the generator while the engine is running.
Inspect the discharge warning light circuit.

Turn the ignition switch to the ON position. Check that the discharge warning light illuminates.
Start the engine. Check that the light goes off.

