2005-2008 Yaris · Service Manual ENGINE

REPAIR

Removal / installation · Vehicles built from Aug 2005


1. REPAIR VALVE SEAT

A062786E01
  1. Apply a light coat of prussian blue (or white lead) to the valve face.

  1. Gently press the valve against the seat.

    NOTICE:
    Do not rotate the valve.

  1. Check the valve face and seat in accordance with the following procedure.

    1. If blue appears 360 ° around the face, the valve is concentric. If not, replace the valve.

    2. If blue appears 360 ° around the valve seat, the guide and face are concentric. If not, resurface the seat.

      Standard width:
      Item
      Specification
      Intake
      1.20 to 1.70 mm (0.0472 to 0.0669 in.)
      Exhaust
      1.11 to 1.61 mm (0.0437 to 0.0634 in.)

  1. A104701
    Using a 45 ° cutter, resurface the valve seat so that the valve seat width is more than the specification.

    NOTICE:
    1. Repair the seat while checking the seating position.
    2. Gradually reduce the force in order to prevent joggling on the resurfaced face.

  1. A118671E01
    Check each valve setting position. Using a 45 ° cutter, resurface the valve seat so that the valve seat contacts in the middle of the valve face.

  1. Using 20 ° and 70 ° cutters, resurface the valve seat so that the valve seat contacts around the entire valve seat and the valve seat width is the specification.

  1. A104703
    Handrub the valve and valve seat with an abrasive compound.

← REASSEMBLY (from Aug 2005)PRECAUTION (from Nov 2005) →