2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT CAM TIMING OIL CONTROL VALVE ASSEMBLY

  1. A093602E02
    Check the resistance.

    1. Measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      6.9 to 7.9 Ω at 20°C (68°F)

      If the result is not as specified, replace the oil control valve assembly.

  1. A099422E01
    Check the operation.

    1. Connect the positive (+) battery lead to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

      Standard:
      Condition
      Specified Condition
      Battery positive (+) voltage applied
      Valve moves to left as shown in illustration
      Battery positive (+) voltage cut off
      Valve moves to right as shown in illustration

      If the result is not as specified, replace the oil control valve.

      NOTICE:
      If the valve cannot return properly because of foreign matter intrusion, a small amount of leakage in the advanced direction may occur and a DTC may be output.

← REMOVAL (from Nov 2005)INSTALLATION (from Nov 2005) →