ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2005
| INSPECT ENGINE OIL |
![]() ![]() |
Check engine oil level.
Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.
If low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill with engine oil to above the full level mark.
Check engine oil quality.

Check the oil for deterioration, water contamination, discoloration and thinning.
If the quality is visibly poor, replace the oil.- Oil grade:
- 20W-50 and 15W-40:
- API grade SL or SM multigrade engine oil
- 10W-30 and 5W-30:
- API grade SL "Energy-Conserving" "Energy-Conserving SM or ILSAC multigrade engine oil"
| CHECK OIL PRESSURE |
![]() ![]() |
Remove the engine oil pressure switch.
Disconnect the connector.
Using a 24 mm deep socket wrench, remove the engine oil pressure switch.
Install the oil pressure gauge with the adaptor.

Start the engine.
Warm up the engine.
Check the oil pressure.
- Specification:
Engine rpm
Oil pressure
750 rpm
30 kPa (0.3 kgf/cm2, 4.3 psi) or more
3000 rpm
200 kPa (2.0 kgf/cm2, 28.4 psi) or more
Remove the oil pressure gauge with the adaptor.
Install the engine oil pressure switch.

Apply adhesive to 2 or 3 threads of the oil pressure switch.
- Adhesive:
- Part No. 08833-00080, THREE BOND 1334, LOCTITE 242 or the equivalent
Using a 24 mm deep socket wrench, install the oil pressure switch.

- Torque:
- 15 N*m{ 153 kgf*cm , 11 ft.*lbf }
- NOTICE:
- Do not start the engine for at least 1 hour after the installation.
Connect the engine oil pressure switch connector.
Check for engine oil leakage.

