2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. A117319
    Install a vinyl hose onto the radiator side.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the water drain plug, then drain the coolant.

    A117375E01


3. REMOVE FAN AND GENERATOR V BELT

A107413E01
  1. Loosen bolt A.

  1. Loosen bolt B.

  1. Loosen bolt C.

  1. Release the drive belt tension and remove the fan and generator V belt.


4. REMOVE GENERATOR ASSEMBLY

A104326
  1. Disconnect the connector.

  1. Remove the terminal cap.

  1. Remove the nut and separate the wire harness from terminal B.

  1. Disengage the 2 clamps and separate the wire harness.

  1. A107405
    Remove the 2 bolts and remove the generator assembly.


5. REMOVE FAN BELT ADJUSTING BAR
  1. Remove the bolt and remove the fan belt adjusting bar.


6. REMOVE WATER PUMP ASSEMBLY

A118794
  1. Remove the 5 bolts and remove the water pump.

  1. A118795
    Remove the gasket.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →