2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL OUTER MIRROR COVER

B101986
  1. Engage the 3 claws on the lower part of the mirror cover.

  1. Engage the 4 claws on the upper part of the mirror cover and install it.

  1. After installing the outer mirror cover, check that there are no gaps between the cover and the mirror body.

    NOTICE:
    If there is a gap between the cover and the mirror body, it may cause noise during driving.

  1. B075313
    Engage the 2 claws of the outer rear view mirror.

  1. Engage the 2 clips and install the mirror.


2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

B118045
  1. Engage the claw, then install the outer rear view mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. w/ Power mirror:
    Connect the connector.


3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

B127219
  1. Connect the front door lock remote control cable and front door inside locking cable.

  1. B116821
    5 Door:
    Engage the 8 clips and install the front door trim board.

  1. B116822
    3 Door:
    Engage the 9 clips and install the front door trim board.

  1. B107840
    Tighten the 4 screws.


4. INSTALL FRONT ARMREST BASE PANEL UPPER (w/ Power Window)

B116819
  1. Connect the connector.

  1. Engage the 5 claws and clip and install the front armrest base panel upper.


5. INSTALL FRONT ARMREST BASE PANEL UPPER (w/o Power Window)

B116854
  1. Engage the 5 claws and clip and install the front door armrest base panel upper.


6. INSTALL DOOR ARMREST COVER

B116818
  1. for 5 Door:
    Engage the 8 claws and 3 clips and install the door armrest cover.

  1. B116851
    for 3 Door:
    Engage the 12 claws and 4 clips and install the door armrest cover.


7. INSTALL DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116863
  1. Install the window regulator handle plate.

  1. Open all the windows.

  1. B116947E01
    Install the front door window regulator handle with clip at the angle shown in the illustration.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← INSPECTION (from Aug 2005)COMPONENTS (from Jan 2006) →