2005-2008 Yaris · Service Manual BODY

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH

B116953
  1. Check the operation.

    1. Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror.

      Standard:
      Measurement Condition
      Mirror Assembly Operation
      Battery positive (+) - Terminal 5 (MV)
      Battery negative (-) - Terminal 4 (COM)
      Turns upward
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 5 (MV)
      Turns downward
      Battery positive (+) - Terminal 3 (MH)
      Battery negative (-) - Terminal 4 (COM)
      Turns left
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 3 (MH)
      Turns right

      If the result is not as specified, replace the outer rear view mirror.

  1. B116955
    w/ Mirror heater:
    Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard Resistance:
      Tester connection
      Specified Condition
      1 (-) - 2 (+)
      8 to 11 Ω at 25°C (75°F)

      If the result is not as specified, replace the outer rear view mirror.

    2. Connect the cable from the negative battery (-) terminal to terminal 1 and the positive battery (+) terminal to terminal 2, then check that the mirror becomes warm.

      Standard:
      Mirror becomes warm.

      HINT:
      It takes a short time for the mirror to become warm.

      If the result is not as specified, replace the outer rear view mirror.


INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH

B116954
  1. Check the operation.

    1. Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror.

      Standard:
      Measurement Condition
      Mirror Assembly Operation
      Battery positive (+) - Terminal 5 (MV)
      Battery negative (-) - Terminal 4 (COM)
      Turns upward
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 5 (MV)
      Turns downward
      Battery positive (+) - Terminal 3 (MH)
      Battery negative (-) - Terminal 4 (COM)
      Turns left
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 3 (MH)
      Turns right

      If the result is not as specified, replace the outer rear view mirror.

  1. B116956
    w/ Mirror heater:
    Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard Resistance:
      Tester connection
      Specified Condition
      1 (-) - 2 (+)
      8 to 11 Ω at 25°C (75°F)

      If the result is not as specified, replace the outer rear view mirror.

    2. Connect the cable from the negative battery (-) terminal to terminal 1 and the positive battery (+) terminal to terminal 2, then check that the mirror becomes warm.

      Standard:
      Mirror becomes warm.

      HINT:
      It takes a short time for the mirror to become warm.

      If the result is not as specified, replace the outer rear view mirror.

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →