2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Aug 2005

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116850
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the front door window regulator handle and clip.

  1. Remove the window regulator handle plate.


3. REMOVE DOOR ARMREST COVER

B116818
  1. for 5 Door:
    Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and 3 clips and remove the door armrest cover.

  1. B116851
    for 3 Door:
    Disengage the 12 claws and 3 clips and remove the door armrest cover.


4. REMOVE FRONT ARMREST BASE PANEL UPPER (w/ Power Window)

B116819
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and clip and remove the front armrest base panel upper.

  1. Disconnect the connector.


5. REMOVE FRONT ARMREST BASE PANEL UPPER (w/o Power Window)

B116854
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and clip and remove the front armrest base panel upper.


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

B107840
  1. Remove the 4 screws.

  1. B116821
    5 Door:
    Disengage the 8 clips.

  1. B116822
    3 Door:
    Disengage the 9 clips.

  1. B127219
    Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.


7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

B118045
  1. w/ Power mirror:
    Disconnect the connector.

  1. Remove the 3 nuts, disengage the claw and remove the outer rear view mirror.


8. REMOVE OUTER MIRROR COVER

B118064
  1. Apply protective tape to the lower part of the mirror body.

  1. Press down the upper part of the mirror and tilt the mirror.

  1. Insert a moulding remover into the 2 clip installation positions on the lower part of the mirror to disengage the 2 clips.

  1. Remove the mirror by pulling it downward.

  1. B118046
    Disengage the 4 claws from the inside of the mirror body.

  1. B101985
    Push the upper part of the mirror cover forward to tilt it, and then disengage the 3 claws on the lower part to remove the outer mirror cover.

← COMPONENTS (from Aug 2005)INSPECTION (from Aug 2005) →