2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Aug 2005

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR COMBINATION LIGHT COVER

E113817E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the rear combination light cover.


3. REMOVE REAR COMBINATION LIGHT ASSEMBLY

E108436
  1. Remove the 2 nuts.

  1. Disconnect the connector.

  1. E113819
    Slide the tail light (rear combination light) toward the rear of the vehicle.


4. REMOVE REAR COMBINATION LIGHT BODY GASKET

E113820
  1. Remove the rear combination light body gasket.

    NOTICE:
    1. Detach the gasket if it adheres to the body.
    2. Do not reuse a removed gasket. Replace it with a new one to prevent water from entering.


5. REMOVE REAR COMBINATION LIGHT BULB

E113821
  1. Disengage the fitting of the rib.

  1. Disengage the claw on the upper side, then on the lower side.

  1. E108440
    Turn the 2 rear combination light bulbs, in the direction indicated by the arrows in the illustration, to remove them.

  1. E108442
    Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to remove it.

  1. E108444
    Remove the rear combination light bulb from the socket and wire.

  1. E113822
    Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to remove it.

  1. E113824
    Remove the rear combination light bulb from the socket and wire.


6. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

E109069
  1. Disconnect the connector and remove the rear combination light socket and wire.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →