2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2006

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

  1. E129681
    Remove the luggage compartment floor mat.


3. REMOVE SPARE WHEEL COVER ASSEMBLY

  1. E129682
    Remove the spare wheel cover assembly.


4. REMOVE DECK FLOOR BOX LH

  1. E129683
    Remove the deck floor box with the deck side box door.


5. REMOVE DECK FLOOR BOX RH

HINT:
Use the same procedure as for the LH side.


6. REMOVE REAR FLOOR FINISH PLATE

  1. E127138
    Disengage the 2 clips and remove the rear floor finish plate.


7. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER

  1. E127139
    Disengage the 5 clips and remove the luggage compartment trim inner cover.


8. REMOVE REAR COMBINATION LIGHT ASSEMBLY

  1. E127140
    Remove the 2 nuts.

  1. Disconnect the connector.

  1. E127141
    Slide the rear combination light assembly toward the rear of the vehicle.


9. REMOVE REAR COMBINATION LIGHT BODY GASKET

  1. E125483
    Remove the rear combination light body gasket.

    NOTICE:
    1. Detach the gasket if it adheres to the body.
    2. Do not reuse a removed gasket.
      Replace it with a new one to prevent water from entering.


10. REMOVE TAIL LIGHT AND STOP LIGHT BULB

  1. E125484
    Turn the tail light and stop light bulb socket and bulb, in the directions indicated by the arrow in the illustration, to remove them.

  1. Remove the tail light and stop light bulb from the light socket.


11. REMOVE TURN SIGNAL LIGHT BULB

  1. E125485
    Turn the turn signal light bulb socket and bulb, in the directions indicated by the arrow in the illustration, to remove them.

  1. Remove the turn signal light bulb from the light socket.


12. REMOVE BACK UP LIGHT BULB

  1. E125486
    Turn the back up light bulb socket and bulb, in the directions indicated by the arrow in the illustration, to remove them.

  1. Remove the back up light bulb from the light socket.

← COMPONENTS (from Jan 2006)INSTALLATION (from Jan 2006) →