2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT MAP LIGHT ASSEMBLY

E107912
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      OFF
      10 kΩ or higher
      1 - 2
      Drivers switch ON
      Below 1 Ω
      1 - 2
      Passengers switch OFF
      Below 1 Ω

      If the result is not as specified, replace the map light.

  1. Check the light operation.

    1. Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 2, then check that the light illuminates.

      standard:
      Light illuminates.

      If the light does not illuminate, replace the bulb.

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →