2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

2. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

3. REMOVE STEERING PAD (w/ Steering Pad Switch)

C117211E01
  1. Using "Torx" socket wrench T30, loosen the 2 bolts completely.

  1. Pull the steering pad toward you.

  1. C117199E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn terminal.


4. REMOVE STEERING PAD (w/o Steering Pad Switch)

C117209E01
  1. Using "Torx" socket wrench T30, loosen the 2 bolts completely.

  1. Pull the steering pad toward you.

  1. C117201E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn terminal.


5. REMOVE STEERING WHEEL ASSEMBLY

  1. C117210E01
    Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.

  1. C117207E01
    Using SST, remove the steering wheel assembly.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of the SST center bolt before using.


6. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

B108275E01
  1. Disengage the 4 claws and remove the steering column cover support.


7. REMOVE STEERING COLUMN COVER

  1. C117204E01
    Remove the 3 screws, disengage the 2 claws, release the tilt lever and remove the steering column lower cover.

  1. C117205E01
    Disengage the claw and remove the steering column upper cover.


8. REMOVE SPIRAL CABLE (w/ Steering Sensor)

B109371E01
  1. Detach the horn connector.

  1. Slide the slider and detach the airbag connector.

  1. Detach the steering sensor connector.

  1. B108277E01
    Disengage the 3 claws and remove the spiral cable.


9. REMOVE SPIRAL CABLE (w/o Steering Sensor)

B108276E01
  1. Detach the horn connector.

  1. Slide the slider and detach the airbag connector.

  1. C118549
    Disengage the 3 claws and remove the spiral cable.


10. REMOVE WIPER SWITCH

E113830E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the wiper switch.

    NOTICE:
    Do not press the claw too hard, as it may be damaged.


11. REMOVE HEADLIGHT DIMMER SWITCH

E113831
  1. Disconnect the connector.

  1. Remove the headlight dimmer switch, as shown in the illustration.

  1. E113832
    Disengage the 2 claws and remove the headlight dimmer switch.

← COMPONENTS (from Aug 2005)INSPECTION (from Aug 2005) →