INSPECTION
Inspection · Vehicles built from Aug 2005
| INSPECT HEADLIGHT DIMMER SWITCH (for LHD, RHD Europe) |
![]() ![]() |
Check the resistance of the light control switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
-
OFF
10 kΩ or higher
10 - 13
TAIL
Below 1 Ω
10 - 13
HEAD
Below 1 Ω
11 - 12
HEAD
Below 1 Ω
Check the resistance of the headlight dimmer switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
9 - 11
FLASH
Below 1 Ω
8 - 11
LOW BEAM
Below 1 Ω
9 - 11
HI BEAM
Below 1 Ω
Check the resistance of the turn signal switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
6 - 7
Right turn
Below 1 Ω
-
Neutral
10 kΩ or higher
5 - 7
Left turn
Below 1 Ω
w/ Front fog light:
Check the resistance of the front fog light switch.Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
-
OFF
10 kΩ or higher
3 - 4
Front fog light switch ON
Below 1 Ω
w/ Rear fog light:
Check the resistance of the rear fog light switch.Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
-
OFF
10 kΩ or higher
2 - 3 - 4
Rear fog light switch ON
Below 1 Ω
| INSPECT HEADLIGHT DIMMER SWITCH (for RHD except Europe) |
![]() ![]() |
Check the resistance of the light control switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
-
OFF
10 kΩ or higher
5 - 8
TAIL
Below 1 Ω
5 - 8
HEAD
Below 1 Ω
6 - 7
HEAD
Below 1 Ω
Check the resistance of the headlight dimmer switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
7 - 9
FLASH
Below 1 Ω
7 - 10
LOW BEAM
Below 1 Ω
7 - 9
HI BEAM
Below 1 Ω
Check the resistance of the turn signal switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
11 - 13
Right turn
Below 1 Ω
-
Neutral
10 kΩ or higher
11 - 12
Left turn
Below 1 Ω
w/ Front fog light:
Check the resistance of the front fog light switch.Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
-
OFF
10 kΩ or higher
1 - 2
Front fog light switch ON
Below 1 Ω
w/ Rear fog light:
Check the resistance of the rear fog light switch.Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
-
OFF
10 kΩ or higher
1 - 2 - 3
Rear fog light switch ON
Below 1 Ω


