REMOVAL
Removal / installation · Vehicles built from Jan 2006
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT BUMPER COVER |
Apply protective tape, as shown in the illustration.

Remove the 7 screws and 3 bolts.

Remove the 2 screw grommets.
Remove the 6 clips.
w/ Fog Light:

Disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/o Fog Light:

Disengage the 6 claws and remove the front bumper cover.
Remove the 2 clips and the screw grommet.

| 3. REMOVE HEADLIGHT ASSEMBLY RH |
Remove the 2 screws and the bolt.

w/ Headlight leveling:
Disconnect the 3 connectors, then remove the headlight.
w/o Headlight leveling:
Disconnect the 2 connectors, then remove the headlight.
| 4. DRAIN WASHER FLUID |
Disconnect the 2 washer hoses from the windshield washer motor and pump, and drain the washer fluid.
| 5. REMOVE WINDSHIELD WASHER JAR ASSEMBLY |
Disconnect the 2 harness clamps.

Disconnect the connector.
Remove the 2 bolts.
Remove the windshield washer jar.
| 6. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY |
Pull the washer motor and pump out of the packing of the washer jar.

