2005-2008 Yaris · Service Manual ENGINE

P0724 Brake Switch "B" Circuit High

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The purpose of this circuit is to prevent the engine from stalling when the brakes are suddenly applied while driving in the lock-up condition. When the brake pedal is depressed, this switch sends a signal to the ECM. Then the ECM cancels the operation of the lock-up clutch while the braking is in progress.
DTC No.
DTC Detection Conditions
Trouble Areas
P0724
Stop light switch remains ON even when vehicle repeats 5 cycles of STOP (less than 3 km/h (1.86 mph)) and GO (30 km/h (18.65 mph) or more)
(2 trip detection logic)
  1. Short in stop light switch signal circuit
  2. Stop light switch
  3. ECM

WIRING DIAGRAM

A128480E01

INSPECTION PROCEDURE

HINT:
Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


1. READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / Data List / Stop Light Switch.

  1. Read the values displayed on the tester.


OK:
Item
Measurement Item: Range (display)
Normal Conditions
Stop Light Switch
Stop light switch status:
ON or OFF
  1. ON : Brake Pedal is depressed
  2. OFF : Brake Pedal is released



OK
CHECK FOR INTERMITTENT PROBLEMS
NG


2. INSPECT STOP LIGHT SWITCH ASSEMBLY
A122560E01
  1. Remove the stop light switch assembly.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Switch Positions
    Specified Conditions
    1 - 2
    Switch pin released
    Below 1 Ω
    Switch pin pushed in
    10 kΩ or higher
    3 - 4
    Switch pin released
    10 kΩ or higher
    Switch pin pushed in
    Below 1 Ω

  1. Reinstall the stop light switch assembly.



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - ECM)

  1. A107923E01
    Disconnect the A21 ECM connector.

  1. Disconnect the A13 stop light switch connector.

  1. Check the resistance.

    Standard resistance (Check for open):
    Tester Connections
    Specified Conditions
    STP (A21-36) - Stop light switch (A13-1)
    Below 1 Ω
    ST1- (A21-35) - Stop light switch (A13-4)

    Standard resistance (Check for short):
    Tester Connections
    Specified Conditions
    STP (A21-36) or Stop light switch (A13-1) - Body ground
    10 kΩ or higher
    ST1- (A21-35) or Stop light switch (A13-4) - Body ground

  1. Reconnect the ECM connector.

  1. Reconnect the stop light switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM


← P0617 Starter Relay Circuit High (from Nov 2005)P2102 Throttle Actuator Control Motor Circuit Low (+ P2103) (from Nov 2005) →